Why do belt delivery opportunities sprinkle
When the belt conveyor is often sprinkled at these places when the forwarding point and the recessed belt are suspended. What are the good solutions for this situation?
Sprinkling at the forwarding point is mainly in the fighter, guide grooves, etc. For example, the belt conveyor is severely overloaded, the guide groove of the belt conveyor is damaged, and the steel plate at the steel plate at the guide slot is compared with the long rubber skirt. This situation can only be used for control and transportation, strengthening protection and maintenance, and doubts will be processed by hand.
When the curvature radius of the concave belt range is small, the radius of the concave segment will suspend the belt. At this moment, the strap formation of the groove changes. Because the belt has now left the groove roller group, usually the corners of the slot become smaller, so that some materials are sprinkled out. Therefore, in the depiction stage, a large concave segment curvature radius should be used to prevent the onset of such conditions.
For example, in order to shorten the tail vehicle, the concrete section is described as no arc transition interval in order to shorten the tail vehicle. When the width of the band is selected, the remaining range is relatively simple.
In addition to the above two situations, the belt conveyor belt will also sprinkle when running off. This is because the belt has changed at the height of the two margins at runtime. This situation can be adjusted by the height of the two bands.
